CoD VET Information
System type: 7895
System serial number: 12-34567
Anchor card CCIN: 52EF
Anchor card serial number: 01-231S000
Anchor card unique identifier: 30250812077C3228
Resource ID: CA1F
Activated Resources: 0000
Sequence number: 0040
Entry check: EC
Go to step 3.
v By using Integrated Virtualization Manager (IVM):
a. Start the IVM, if it is not running already.
b. In an IVM session, enter the lsvet -t code command.
The following is an example of the lsvet command output:
Note: When you request the activation code, you must supply the information that is
emphasized in the following example.
sys_type=7895,sys_serial_num=12-34567,anchor_card_ccin=52EF,
anchor_card_serial_num=01-231S000, anchor_card_unique_id=30250812077C3228,
resource_id=CA1F,activated_resources=0000,sequence_num=0040, entry_check=EC
Go to step 3.
3. Send a request for the VET activation code for your replacement management card to the System p
Capacity on Demand mailbox at pcod@us.ibm.com.
If the ASMI was used to get the VET information, include the following fields and their values:
v System type
v System serial number
v Card type
v Card serial number
v Card ID
If the HMC or FSM was used to get the VET information, include the following fields and their
values:
v System type
v System serial number
v Anchor card CCIN
v Anchor card serial number
v Anchor card unique identifier
If the IVM lsvet -t code command was used to get the VET information, include the following fields
and their values:
v sys_type
v sys_serial_num
v anchor_card_ccin
v anchor_card_serial_num
v anchor_card_unique_id
Following is an example of a statement that you can include in the email:
Provide a VET activation code for the new
management card (anchor card) in my Flex power compute node.
The System p Capacity on Demand site then generates the code and posts the VET activation code on
the website.
4. Go to the Capacity on Demand Activation code web page to retrieve your code.
Chapter 6. Installing and removing components 79
To Next Page
Loading...
Need help?
General