The corrected content is: If you exceed the allowed number of adapter ports,
you must set the onboard adapters to initiator or unconfigured before
installing the expansion adapters.
Changes to the first step in the topic "Configuring onboard adapters for
target mode"
The following existing content is incorrect:
1. If you have already connected the port to a switch or fabric, take it offline
by entering the following command:
fcp config adapter down
adapter is the port number. You can specify more than one port.
Example
fcp config 0c 0d down
Ports 0c and 0d are taken offline.
Note: If the adapter does not go offline, you can also remove the cable
from the appropriate adapter port on the system.
The corrected content is as follows:
1. Verify that the FC ports are not already configured as target ports by
entering the following command:
fcadmin config
Example
fcadmin config
Local
Adapter Type State Status
---------------------------------------------------
0a initiator CONFIGURED online
0b initiator CONFIGURED online
0c target CONFIGURED online
0d target CONFIGURED online
The preceding output displays two ports for host access.
----------------------------------------------------
140 IBM System Storage N series: Data ONTAP 8.0.4 7-Mode Release Notes
To Next Page
Loading...
Need help?
General