v “Tape devices behind DataFort are not detected unless a known SCSI
device is mapped to LUN 0” on page 106
For more information about all the limitations in the Data ONTAP 8.0 release
family, see “Known problems and limitations” on page 87.
Known limitations changed in Data ONTAP 8.0.3 7-Mode
There are no known limitations that have been changed in Data ONTAP 8.0.3
7-Mode.
For more information, see “Known problems and limitations” on page 87.
Limitations removed in Data ONTAP 8.0.3 7-Mode
The following limitations are removed in Data ONTAP 8.0.3 7-Mode:
v Exportfs commands via non-interactive ssh fail intermittently
v Potential issue after removing disk ownership in Maintenance mode
v FPolicy quota and user reports show incorrect file size
v CIFS termination required before issuing a lock break
v Data transfer speed reduces when LSI Logic 1030 Ultra320 SCSI HBA is
used with tape drives
v Shutting down a storage system when SMTape operations are active might
result in a panic
Documentation changes for Data ONTAP 8.0.3 7-Mode
The following new or changed information supplements the documentation
you received for Data ONTAP 8.0.3 7-Mode:
v “Changes to the Data ONTAP Upgrade and Revert/Downgrade Guide” on
page 112
v “Changes to the System Administration Guide” on page 122
v “Changes to the Storage Management Guide” on page 128
v “Changes to the High-Availability Configuration Guide” on page 132
v “Changes to the Network Management Guide” on page 133
v “Changes to the Block Access Management Guide for iSCSI and FC” on
page 138
v “Changes to the Data Protection Online Backup and Recovery Guide” on
page 141
v “Changes to the MultiStore Management Guide” on page 144
v “Changes to the Gateway MetroCluster Guide” on page 148
8 IBM System Storage N series: Data ONTAP 8.0.4 7-Mode Release Notes