For more information, see “Replaced or removed commands in Data ONTAP
8.0 7-Mode” on page 56.
New options in Data ONTAP 8.0.2 7-Mode
Data ONTAP 8.0.2 7-Mode includes the following options:
v snapvault.snapshot_for_dr_backup
v interface.blocked.mgmt_data_traffic
v nfs.always.deny.truncate
For more information, see “New options in Data ONTAP 8.0 7-Mode” on page
57.
Changed options in Data ONTAP 8.0.2 7-Mode
Data ONTAP 8.0.2 7-Mode includes the following changed option:
v autosupport.minimal.subject.id
v cifs.max_mpx
For information about all new and changed command and options in the Data
ONTAP 8.0 7-Mode release family, see “New and changed commands and
options” on page 47.
Requirements for running Data ONTAP 8.0.
The following requirement that was included in earlier Data ONTAP 8.0.x
Release Notes has been removed from Data ONTAP 8.0.2 7-Mode:
v Storage systems that support Multipath Storage
For more information, see “Changed options in Data ONTAP 8.0 7-Mode” on
page 59.
New cautions in Data ONTAP 8.0.2 7-Mode
The following new cautions were introduced in Data ONTAP 8.0.2 7-Mode:
v “iSCSI traffic not supported on e0M and e0P interfaces” on page 70
v “New reversion and downgrade procedures” on page 72
v “Certificates signed with MD5 could cause loss of connectivity to secure
clients” on page 73
For more information, see “Important cautions” on page 65.
10 IBM System Storage N series: Data ONTAP 8.0.4 7-Mode Release Notes
To Next Page
Loading...
Need help?
General