Limitations removed in Data ONTAP 8.0.2 7-Mode
The following limitations were removed from Data ONTAP 8.0.2 7-Mode:
v The ifconfig command and the N3400 e0P port
v Creating more than 64 mirrored aggregates might impair disaster recovery
v Forcing a FlexVol volume online must be done in diag mode
v Do not disable the IP fastpath option on an N6200 series system in a High
Availability (HA) pair
v Incorrect warning of termination in spite of a successful giveback
v Brocade 200E switch speed must be set manually
v Enable caching with NIS lookup
v Storage system panic when adding preferred domain controllers
Documentation changes for Data ONTAP 8.0.2 7-Mode
The following new or changed information supplements the documentation
you received for the Data ONTAP 8.0.2 7-Mode release:
v “Changes to the System Administration Guide” on page 122
v “Changes to the Storage Management Guide” on page 128
v “Changes to the Network Management Guide” on page 133
v “Changes to the File Access and Protocols Management Guide” on page 135
v “Changes to the Block Access Management Guide for iSCSI and FC” on
page 138
v “Changes to the Data Protection Online Backup and Recovery Guide” on
page 141
v “Changes to the Data Protection Tape Backup and Recovery Guide” on
page 142
v “Changes to the MultiStore Management Guide” on page 144
v “Changes to the Storage Efficiency Management Guide” on page 147
v “Changes to the Gateway Implementation Guide” on page 147
For more information about important documentation changes, see “Changes
to published documentation” on page 111.
12 IBM System Storage N series: Data ONTAP 8.0.4 7-Mode Release Notes
To Next Page
Loading...
