v “Tape backup and volume move operations must not be performed
simultaneously” on page 107
v “SMTape restore to an offline volume overwrites the data on that volume”
on page 107
v “Deleted files occupy additional space on SMTape restored volumes” on
page 107
For information on all known limitations in the Data ONTAP 8.0 release
family, see “Known problems and limitations” on page 87.
Known issues and limitations removed in Data ONTAP 8.0.1
7-Mode
The following known issues and limitations were removed from Data ONTAP
8.0.1 7-Mode:
v The -m option for the disk replace start command is not recognized
v Attempting to assign more than 500 disks or array LUNs with a single disk
assign command causes a system panic
v Qtree quotas might prevent explicit quotas from overriding the default
v If you establish a volume SnapMirror relationship between a source system
with Data ONTAP 7.x and a destination system with Data ONTAP 8.0
v Down nodes in a cluster containing a FlexCache origin volume can prevent
the FlexCache volume from connecting to the origin
Documentation changes for Data ONTAP 8.0.1 7-Mode
The following new or changed information supplements the documentation
you received for the Data ONTAP 8.0.1 7-Mode release:
v “Changes to the System Administration Guide” on page 122
v “Changes to the File Access and Protocols Management Guide” on page 135
v “Changes to the Block Access Management Guide for iSCSI and FC” on
page 138
v “Changes to the Data Protection Online Backup and Recovery Guide” on
page 141
v “Changes to the Data Protection Tape Backup and Recovery Guide” on
page 142
v “Changes to the MultiStore Management Guide” on page 144
v “Changes to the Storage Efficiency Management Guide” on page 147
For more information about important documentation changes, see “Changes
to published documentation” on page 111.
16 IBM System Storage N series: Data ONTAP 8.0.4 7-Mode Release Notes
To Next Page
Loading...
Need help?
General