Found SnapLock disk:v5.29 Use fcadmin device_map for shelf and
slot info This release does not support SnapLock.Remove the
SnapLock disks from this system.
Found SnapLock disk: v5.32 Use fcadmin device_map for shelf and slot info
This release does not support SnapLock.Remove the SnapLock disks from
this system This release does not support SnapLock.
Halting the system!!!
To recover-boot with a release that supports SnapLock or unplug the
SnapLock disks.
In such a scenario, contact IBM technical support immediately.
If you upgrade a storage system with the SnapLock license
to Data ONTAP 8.0 or later releases in the 8.0.x family
You cannot add new SnapLock licenses in a storage system running on Data
ONTAP 8.0 or later. Previously installed SnapLock licenses are retained, but
are disabled. You can view the SnapLock license using the license command;
however, all operations that require a SnapLock license fail. Therefore, you
cannot create new SnapLock volumes or aggregates in Data ONTAP 8.0 or
later.
A storage system might have the SnapLock license enabled, without any
SnapLock volumes or aggregates. In such a case, if you upgrade the storage
system to Data ONTAP 8.0 or later, the SnapLock license is disabled
automatically and an error message snaplock.unsupported.version is raised
while the storage system is booting up. The SnapLock license is enabled
automatically when you boot with a Data ONTAP release that supports the
SnapLock feature.
If you upgrade a storage system with SnapLock volumes and
aggregates to Data ONTAP 8.0 or later releases in the 8.0.x
family
If you upgrade a storage system containing SnapLock volumes and aggregates
to Data ONTAP 8.0 or later, the storage system halts.
The storage system console displays a list of disks that contain the SnapLock
volumes and aggregates. Following is an example of an error message on the
storage system console:
82 IBM System Storage N series: Data ONTAP 8.0.4 7-Mode Release Notes
To Next Page
Loading...
Need help?
General