Creating the Error Log
1. Load the Advanced Diagnostics diskette from drive A.
2. Press 0 (SYSTEM CHECKOUT), then Enter.
3. Depending on the options installed in the system, questions about
attached devices may appear on the screen. Answer as required; then
press Enter.
4. Press Y or N (IS THE LIST CORRECT (Y/N)?), then Enter.
5. Press 2 (LOG UTILITIES), then Enter.
6. Press 0 (START ERROR LOG), then Enter.
7. Press 0 (LOG TO DISKETTE, OR PRINTER (0/1)?), then Enter.
8. If you are logging to diskette, press A or B (ENTER THE DRIVE ID
FOR ERROR LOG?), then Enter.
9. Press 9 (END LOG UTILITIES), then Enter.
Starting the Test
1. Press 1 (RUN TESTS MULTIPLE TIMES), then Enter.
2. Select the device you suspect has a failure, then press Enter.
3. Select the number of times the test is to be run, then press Enter.
4. Press N (WAIT EACH TIME AN ERROR OCCURS (Y/N)?), then Enter.
5. Follow any instructions on the screen and select all available tests.
Note: Do not press any keys during the keyboard test.
6. To end (RUN TEST CONTINUOUSLY), press and hold the Ctrl key;
then press the Break key. The system completes testing and returns to
the Installed Devices menu.
Display the Error Log
1. Depending on the options installed in the system, questions about
attached devices appear on the screen. Answer as required; then press
Enter.
2. Press Y or N (IS THE LIST CORRECT (Y/N)?), then Enter.
3. Press 2 (LOG UTILITIES), then Enter.
4. Press 2 (DISPLAY LOG), then Enter.
5. Press A or B (ENTER THE DRIVE ID FOR ERROR LOG?), then Enter.
3-10
To Next Page
Loading...
Need help?
General