IBM PS/1 - Software Installation Procedure

Software Installation Procedure
The IBM PS/1 Recovery Diskette includes an Install program that can be
used to restore the original PS/1 system software with the IBM Original PS/1
Software diskettes.
Refer to Appendix, “Model Configurations and FRU Part Numbers” on
page A-1 to determine the correct software FRU part number. (For
European countries, refer to Table A-5 on page A-11.) Then, install the ori-
ginal PS/1 software on the hard disk drive. Use the following procedure:
1. Power off the system unit.
2. Insert the IBM PS/1 Recovery Diskette into drive A.
3. Power on the system unit.
4. Select “Install PS/1 Software” item on the IBM DOS SHELL menu.
5. Follow the instructions on the display. (You will be prompted for each of
the IBM Original PS/1 Software diskettes).
6. When the Install program has finished, remove the diskette and press
Ctrl-Alt-Del to restart the system.
4-48