2080—Lithium Battery
Cover (2005).
Insert the tip of a screwdriver under the clip and raise it carefully.
Remove the battery.
CAUTION:
The lithium battery presents a fire, explosion, or severe burn risk. Do
not recharge it, disassemble it, heat it above 100°C (212°F), incinerate
it, or expose its cell contents to water. Dispose of the battery as
required by local ordinances or regulations.
Warning: The battery is located on the system board. Be careful when
removing or replacing the battery. If the battery clip is broken, the system
board must be replaced.
Note: Run the Configuration Utility after installing a battery.
1
2
Battery
System
Board
Retaining
Clip
Figure 4-29. 486SX, 486DX, and 486DX2 (72-Pin Memory SIMM) System
Boards
Repair Information 4-43
To Next Page
Loading...
Need help?
General
