Safety Inspection Guide
General Guidelines
The purpose of this Safety Inspection Guide is to aid you in identifying pos-
sible unsafe conditions on machines that are being inspected for a Mainte-
nance Agreement. Each machine has needed items installed to provide the
operators and service personnel with an acceptable level of safety. This
guide lists only these items. Good judgment should be used to identify pos-
sible safety conditions not covered by this Safety Inspection Guide.
If any unsafe conditions are present, you must find out how serious the
hazard is and if you can continue before you correct the hazard.
A copy of all current Service Memorandums (SMs), Engineering Change
Announcements (ECAs), and feature/model changes, along with the machine
history, should be reviewed.
Check the following items:
Damaged, missing, or changed parts, especially in the area of the
On/Off switch and the power supply.
Damaged, missing, or changed covers.
Possible safety exposure from any non-IBM attachments.
Safety Inspection Guide 6-1
To Next Page
Loading...
Need help?
General
