8. If the adapter is not being replaced, install an expansion-slot cover in the
expansion-slot opening.
9. If you are instructed to return the adapter, follow all packaging instructions, and
use any packaging materials for shipping that are supplied to you.
Installing an adapter
For information about the types of adapters that the server supports and other
information that you might consider when you install an adapter, see the User’s
Guide. For the locations of the expansion slots and optional device connectors see
“System-board optional-devices connectors” on page 11.
Notes:
1. If you are replacing a Remote Supervisor Adapter II SlimLine, it must be
installed in its dedicated connector on the system board (see “System-board
optional-devices connectors” on page 11).
2. When you start the server for the first time after you install a Remote Supervisor
Adapter II SlimLine, the startup process will take several minutes longer than a
typical startup.
To install a replacement adapter, complete the following steps.
84 System x3200 Types 4362 and 4363: Problem Determination and Service Guide
To Next Page
Loading...
Need help?
General
