hot-swap drive
backplane
activity
LED 5
status LED 5
hot-swap drives, SAS or SATA
installing
94
removing 93
hot-swap power supply cage
installing
117
removing 116
I
IBM Configuration/Setup Utility program
menu
choices 130
starting 130
using 130
important notices 2
indicators 4
installing
adapter
84
battery 103
bezel
lower
80
upper 82
CD drive 88
DIMMs 102
diskette drive 88
drives, bay 1, 2, or 3 88
DVD drive 88
fan
front,
assembly 108
rear 106
fan sink 125
front USB connector assembly 115
front-panel assembly 114
hot-swap drives 94
hot-swap power supply cage 117
hot-swap SAS or SATA drives 94
internal drives 86
memory modules 102
microprocessor 125
power supply
hot-swap
100
non-hot-swap 122
Remote Supervisor Adapter II SlimLine 84
SAS/SATA controller 119
SAS/SATA hard disk drive backplane 112
side cover 78
simple-swap backplate 110
simple-swap drives 97
simple-swap SATA drives 97
system board 128
tape drive 88, 91
intermittent problems 32
internal connectors 9
internal drives
installing
86
removing 86
IPMI 132
J
jumpers
boot
block 13
clear CMOS 13
force power-on 13
mini-BMC force update 13
K
keyboard connector 6
keyboard problems 32
L
LED
AC
power 7
LEDs
CD
drive activity 5
diskette drive activity 5
DVD drive activity 5
Ethernet link status 7
Ethernet transmit/receive activity 7
hard disk drive activity 4
hot-swap hard disk drive activity 5
hot-swap hard disk drive status 5
power-on 4
system board 12
system-error 4
LSI Configuration program 136
M
memory module
specifications
3
memory modules
installing
102
removing 101
memory problems 34
messages
diagnostic
43
microprocessor
cache
132
installing 125
problems 35
removing 123
specifications 3
mini-BMC force update jumper 13
minimum configuration 64
modes, Ethernet 136
monitor problems 35
mouse connector 6
mouse problems 33
N
network operating system (NOS) installation
with
ServerGuide 135
without ServerGuide 135
NMI 133
notes 2
Index 149
To Next Page
Loading...
Need help?
General
