IBM System x3200 User Manual

v Follow the suggested actions in the order in which they are listed in the Action column until the problem
is solved.
v See Chapter 3, “Parts listing, System x3200 Types 4362 and 4363,” on page 67 to determine which
components are customer replaceable units (CRU) and which components are field replaceable units
(FRU).
v If an action step is preceded by “(Trained service technician only),” that step must be performed only by a
trained service technician.
System-error log message Action
System is over recommended voltage for +3.3V
1. Reseat the following components:
a. Hot-swap power supplies, if any are installed
b. Power supply cables on the system board
2.
(Trained service technician only) Replace the system board.
System is over recommended voltage for 1.5V
CPU
1. Reseat the following components:
a. Hot-swap power supplies, if any are installed
b. Power supply cables on the system board
2.
(Trained service technician only) Replace the system board.
System is over recommended voltage on VRM 1 (Trained service technician only) Reseat the microprocessor.
System is under recommended voltage for
+3.3V
1. Reseat the following components:
a. Hot-swap power supplies, if any are installed
b. Power supply cables on the system board
2.
(Trained service technician only) Replace the system board.
System is under recommended voltage for 1.5V
CPU
1. Reseat the following components:
a. Hot-swap power supplies, if any are installed
b. Power supply cables on the system board
2.
(Trained service technician only) Replace the system board.
System is under recommended voltage on VRM
1
(Trained service technician only) Reseat the microprocessor.
System log 75% full Clear the current logs.
System log cleared Information only.
System Memory Error
1. Reseat the DIMMs.
2. Replace the DIMMs.
System over recommended voltage for +12V
1. Reseat the following components:
a. Hot-swap power supplies, if any are installed
b. Power supply cables on the system board
2.
(Trained service technician only) Replace the system board.
System over recommended voltage on +2.5V
1. Reseat the following components:
a. Hot-swap power supplies, if any are installed
b. Power supply cables on the system board
2.
(Trained service technician only) Replace the system board.
System over recommended voltage on
continuous +5V
1. Reseat the following components:
a. Hot-swap power supplies, if any are installed
b. Power supply cables on the system board
2.
(Trained service technician only) Replace the system board.
58 System x3200 Types 4362 and 4363: Problem Determination and Service Guide

IBM System x3200 Specifications

General

Form Factor	Tower
Network	Integrated Gigabit Ethernet
Processor	Intel Xeon 3000 sequence, Intel Pentium Dual-Core processor, Intel Celeron processor
Processor Cores	Dual-Core
Chipset	Intel 3000
Memory	Up to 8GB DDR2
Memory Slots	4
Storage	SATA HDD
RAID Support	RAID 0, 1
Drive Bays	4 internal 3.5-inch