Resume normal operation when detecting an incoming call:
Enter the RediSafe suspend mode:
Set power on or off for the serial device attached to the serial port:
Set the processor speed:
AC: Specifies battery mode when the AC Adapter is connected.
DC: Specifies ac mode when using battery power.
Note:
If the AC or DC option is not specified, this command is effective on the current
power management mode set by the PM command.
POwer
xx
[AC | DC]
RI Enable | Disable —
SAfe Enable | Disable —
SErial ON | OFf —
Note: If the AC or DC option is not specified, this command is effective on the current
power management mode set by the PM commands.
Parameter1 Parameter2 Parameter3 Parameter4
SPeed Fixed | Auto MAX | Medium |
Slow
[AC | DC]
Appendix B. Using PS2 Commands 201
To Next Page
Loading...
