IBM TS4300 - Removing the drive cover

3. Remove the drive brick from the sled by completing these steps:
a. Remove the four screws (two on each side of the sled 4) that secure the sled to the drive brick.
b. Pull the drive brick out of the front of the sled far enough to unplug the cables (5). Some of the
cables and connectors are small and can be delicate, so be careful when you are unplugging them.
Figure 111. The drive brick, showing the cables to be unplugged.
Note: Make sure to note where each cable is connected, so they can be connected correctly later.
c. Remove the drive brick from the sled.
Removing the drive cover
Procedure
1. Ground yourself to the drive by using an ESD Kit.
2. Remove the cover of the full height drive by completing these steps:
a. Remove the four cover-mounting screws and washers 1.
b. Remove the cover by lifting it up.
IBM Condential
200IBM TS4300 Tape Library 机器类型 3555： 用户指南