Icom F6400DS 11 - Pairing with a Headset

11
Bluetooth
®
OPERATION
11-6
Pairing with a headset
This section describes how to pair with a Bluetooth
®
headset using the Portable Ten-key and the Simple
key types or Mobile LCD types.
Step 1: Entering the Pairing mode (Headset)
L See the headset’s instruction manual for details.
Step 2: Turning ON the Bluetooth
®
function
(Transceiver)
L See page 11-3 for details.
Step 3: Searching for the headset (Transceiver)
1. Push [Menu] to display the “Menu” screen.
2. Push [Left] or [Right] to select “Bluetooth,” then
push [OK].
3. Push [Up] or [Down] to select “BT Device List,”
then push [OK].
4. Push [Up] or [Down] to select “Find Device,” then
push [OK].
TIP: If the transceiver has been connected to the
Bluetooth
®
device before, its name may be displayed
in step 4. In that case, push [Up] or [Down] to select
it, then push [OK] to connect.
5. Push [Up] or [Down] to select “Headset,” then
push [OK] to start searching.
6. When pairable headsets are found, their names
are displayed on the screen.
TIP:Ifthetransceivercannotndanypairable
headsets, the following screen is displayed. In that
case, do step 4 to search for a headset again.
☞ Continued on the next page.
NOTE: For the Portable Non-display type and
Mobile Segment type
To pair with a headset, see page 11-4 for details.
Previous view