Icom F6400DS 11 - Accepting a Pairing Request from a Bluetooth Device

11
Bluetooth
®
OPERATION
11-11
Accepting a pairing request from a Bluetooth
®
device
This section describes how to accept a pairing request
from a Bluetooth
®
device.
Portable: For the Ten-key and the Simple key types
Mobile: For the LCD types
Step 1: Preparing the Bluetooth
®
device
Step 2: Turning ON the Bluetooth
®
function
(Transceiver)
L See page 11-3 for details.
Step 3: Entering the Waiting Pairing mode
(Transceiver)
1. Push [Menu] to display the “Menu” screen.
2. Push [Left] or [Right] to select “Bluetooth,” then
push [OK].
3. Push [Up] or [Down] to select “Waiting Pairing,”
then push [OK].
• Enters the Waiting Pairing mode.
TIP: You can enter the Waiting Pairing mode by
pushing [Waiting Pairing].
Step 4: Entering the Pairing mode
(Bluetooth
®
device)
LSee the device’s instruction manual for details.
Step 5: Sending a Pairing request to the
transceiver ( Bluetooth
®
device )
1. The device displays the transceiver’s Bluetooth
®
unit name on the screen.
2. Select the displayed name to send a pairing
request.
• The Bluetooth
®
device sends a pairing request.
L See the device’s instruction manual for details.
LYoucanconrmthetransceiver’sBluetooth
®
unit
name on the “BT Device Info” screen. (p. 6-14)
Step 6: Receiving a Pairing Request (Transceiver)
1. “Passkey? MMMMM” is displayed on the
transceiver.
2. Confirm the displayed passkey is the same as
yours.
3. Push [Left] or [Right] to select <Accept>, then
push [OK].
• Pairing starts.
4. After the pairing is complete, the device’s name is
displayed in the “BT Device List” screen.
5. Push [Up] or [Down] to select the Bluetooth
®
device to connect, then push [OK].
☞ Continued on the next page.
Previous view