Icom F6400DS 11 - D Transmitting a Revive Command; D Transmitting a Stun Command

7
NXDN™ OPERATION
7-12
Transmitting a call (Continued)
D Transmitting a Stun command
A Stun command enables you to send a signal that
will stun the target station.
<Menu operation>
Portable: For the Ten-key and the Simple key types
Mobile: For the LCD types
(Menu > Signaling/Call > Call Menu)
1. Push [Menu] to display the Menu screen.
2. Push [Left] or [Right] to select “Signaling/Call,”
then push [OK].
3. Push [Up] or [Down] to select “Call Menu,” then
push [OK].
4. Push [Up] or [Down] to select the Individual ID,
then push [OK].
5. Push [Up] or [Down] to select “Stun,” then push
[PTT] to transmit the Stun command.
• The target station is stunned.
L “Success” is displayed after receiving an
acknowledgement from the target station.
L “Failed” is displayed if the target station does not
send back an acknowledgement.
D Transmitting a Revive command
A Revive command enables you to send a signal that
will revive a stunned station.
<Menu operation>
Portable: For the Ten-key and the Simple key types
Mobile: For the LCD types
(Menu > Signaling/Call > Call Menu)
1. Push [Menu] to display the Menu screen.
2. Push [Left] or [Right] to select “Signaling/Call,”
then push [OK].
3. Push [Up] or [Down] to select “Call Menu,” then
push [OK].
4. Push [Up] or [Down] to select the Individual ID,
then push [OK].
5. Push [Up] or [Down] to select “Revive,” then push
[PTT] to transmit the Revive command.
• The stunned station is revived.
L “Success” is displayed after receiving an
acknowledgement from the target station.
L “Failed” is displayed if the target station does not
send back an acknowledgement.
Previous view