Icom F6400DS 11 - D Transmitting an Emergency Call; Emergency Call

4
ADVANCED OPERATION
4-3
Emergency call
D Transmitting an Emergency call
• The [Emergency] key
When a user holds down [Emergency] for the Emer
SW ON Timer preset time.
L If a user holds down [Emergency] for the Emer SW
OFF Timer set time before the Reminder Timer set
time expires, the Emergency mode is canceled.
(Example)
• Emer SW ON Timer: 10 seconds
• Reminder Timer: 10 seconds
IMPORTANT: It is recommended that the dealer sets
an Emergency channel in each zone, to provide a
reliable Emergency call operation.
NOTE: Depending on the presetting, the following
functions may be automatically activated.
Auto TX function
After an Emergency call transmission, the
transceiver transmits the microphone audio for a
preset period of time.
Auto RX function
After an Emergency call transmission, the
transceiver stands by in the Audible mode for a
preset period of time.
When the transceiver enters the Emergency mode, a
countdown starts. The transceiver counts down during
the Reminder Timer set time.
Before the Reminder Timer set time expires, the
transceiver transmits an Emergency call once, or
repeatedly*, on the specied Emergency channel.
If no Emergency channel is specied, the Emergency
call is made on the previously selected channel.
* Depending on the presetting.
L The transceiver automatically transmits a
repeat Emergency call until it receives an
acknowledgement, or until a user turns OFF the
transceiver.
L If the transceiver is set for Silent operation, it
transmits an Emergency call without a beep
sounding or the status indicator lighting.
☞ Continued on the next page.
[Emer]
10 sec. 10 sec.
Operation
Time
ON Timer
Reminder
Timer
Emergency
Timer
Enters the
Emergency mode.
Sends an
Emergency call.
The transceiver enters the Emergency mode through
the following functions:
TIP: A user can transmit the Emergency call in the
2-Tone, 5-Tone, NXDN™, or MDC 1200 signaling
system.
Previous view