Icom F6400DS 11 - Section 5 SCAN OPERATION; Starting a Scan

5
SCAN OPERATION
5-2
Starting a Scan
A Scan checks for signals on each channel and stops
when a signal is received.
NOTE: Two or more channels must be preset to start
a Scan.
<Key operation>
Push [Scan Start/Stop] to start a Scan.
• “ ” blinks. (Depending on the transceiver’s version.)
L When a signal is detected, the Scan pauses on the
channel until the signal disappears, and then the Scan
resumes.
<Menu operation>
Portable: For the Ten-key and the Simple key types
Mobile: For the LCD type
(Menu > Channel/Scan > Scan Start/Stop)
1. Push [Menu] to display the Menu screen.
2. Push [Left] or [Right] to select “Channel/Scan,”
then push [OK].
3. Push [Up] or [Down] to select “Scan Start/Stop,”
then push [OK].
4. Push [Up] or [Down] to select “ON,” then push
[OK].
• The Scan starts.
L When a signal is detected, the Scan pauses on the
channel until the signal disappears, then the Scan
resumes.
5. Hold down [Back] for 1 second to return to the
standby screen.
• “ ” blinks while scanning. (Depending on the
transceiver’s version.)
Previous view