6
MENU SCREEN
6-9
Call List Select
Selects a calling destination. After selecting, push
[PTT] to transmit the voice call to the selected
destination. (pp. 7-3, 7-4)
Call Menu
In the Analog mode (MDC 1200 only)
Selects a calling destination and a call type (Call
Alert, Radio Check, Stun, Revive, and Sel Call).
After selecting, push [PTT] to transmit the call to the
selected destination. (pp. 8-5, 8-7, 8-9, 8-11, 8-13)
In the Digital mode
Selects a calling destination and a call type (Status,
Message, Write Message, Call Alert, Remote Monitor,
Radio Check, Stun, Revive, and Kill). After selecting,
push [PTT] to transmit the call to the selected
destination. (pp. 7-5, 7-7, 7-9 ~ 7-13)
NOTE: When the call type is “Status,” “Message,”
or “Write Message,” you can select or directly enter
a message before transmitting it. After selecting or
entering a message, push [PTT] to transmit it. See
pages 7-5, 7-7, and 7-9 for details.
Clear Incoming
In the Digital mode
Clears the received call log from the Incoming list.
(p. 7-22)
Clear Outgoing
In the Digital mode
Clears the transmit call log from the Outgoing list.
(p. 7-23)
DTMF Autodial
In the Analog mode
In the Digital mode
Displays the “DTMF Autodial” screen. Then, push
[Up] or [Down] to select a DTMF code. After selecting,
push [PTT] to transmit the selected DTMF code.
Group Select
Displays the “Group Select” screen. Then, push [Up]
or [Down] to select a Group ID from the Call List. After
selecting, push [PTT] to transmit a Group call. (p. 7-4)
Signaling/Call
Incoming
In the Analog mode (MDC 1200 only)
In the Digital mode
Displays a log of the received Individual call, Call Alert
call, Status message, and Message. (pp. 7-20, 8-22)
Individual Select
Displays the “Individual Select” screen. Then, push
[Up] or [Down] to select a Individual ID from the Call
List. After selecting, push [PTT] to send a Individual
call. (p. 7-3)
Message
In the Analog mode (MDC 1200 only)
In the Digital mode
Displays the “Message” screen. Then, push [Up] or
[Down] to select a message. After selecting, push
[PTT] to send the Message to the currently selected
destination. (pp. 7-8, 8-16)
Outgoing
In the Digital mode
Displays a log of the transmitted Individual calls and
Call Alert calls. (p. 7-21)
Status
In the Analog mode (MDC 1200 only)
In the Digital mode
Displays the “Status” screen. Then, push [Up] or
[Down] to select a status message. After selecting,
push [PTT] to send the message to the currently
selected destination. (pp. 7-6, 8-14)
Write Message
In the Digital mode
Enables the user to directly enter a message. After
entering, push [PTT] to transmit it. (p. 7-9)
To Next Page
Loading...
