To Next PageTo Next PageWhat to do if Icom Transceiver frequency cannot be set?
If you're unable to set the frequency on your Icom Transceiver, it might be because the frequency lock function is activated. Try turning the function OFF. Alternatively, priority watch might be paused on the watching frequency. Push [(PRO)PRIO] or [(MEM)PRIO] to resume the watch.
Why won't my Icom IC-2800H turn on?
Your Icom Transceiver might not be turning on due to a few reasons. There could be a poor contact with the power connector, so check the connector pins. The polarity of the power connection could be reversed; in that case, reconnect the power cable, making sure to observe the correct polarity. Also, check the fuse and replace it if it's damaged.
Why doesn't scan operate on my Icom IC-2800H Transceiver?
If the scan function isn't working on your Icom Transceiver, it could be due to a few reasons: * The squelch might be open. Set the squelch to the threshold point. * The selected programmed scan edge memory channels (e.g. 1A/1B) could have the same frequencies. Reset the scan edges. * Only 1 memory channel might be programmed, or other channels are set as skip channels. Program other memory channels or cancel the memory skip function in the desired channels.
Why can't I contact another station with my Icom IC-2800H?
If you're unable to contact another station with your Icom Transceiver, it's possible that the transceiver is set to semi-duplex. Set it to simplex. Also, the other station might be using tone squelch; in that case, turn OFF tone squelch.
Why are sub band signals not audible on my Icom IC-2800H Transceiver?
If you can't hear sub band signals on your Icom Transceiver, the sub band mute function might be activated. Turn the function OFF.
Why does Icom IC-2800H transmission automatically cut off?
If your Icom Transceiver's transmission is automatically cutting off, the time-out timer is likely activated. Set the timer to OFF.
What to do if Icom IC-2800H Transceiver transmission continues when PTT is released?
If your Icom Transceiver continues to transmit even after you release the PTT button, the one-touch PTT function is probably activated. Turn the function OFF.
General| Brand | Icom |
|---|---|
| Model | IC-2800H |
| Category | Transceiver |
| Language | English |
