Icom IC-2800H

74
15
OTHER FUNCTIONS
■ Demonstration display
A demonstration function is available at power ON.This func-
tion gives you a quick visual introduction to the function dis-
play indicators.
q While pushing [CHG/L], push [POWER] to turn power ON.
•The transceiver cycles through a visual tour of the function dis-
play indicators.
w Push any switch to exit demonstration mode and enter the
normal operating condition temporarily.
The transceiver automatically returns to demonstration
mode after 2 min. in which no operations are performed.
To deactivate the demonstration display permanently, turn
power OFF, then while pushing [CHG/L], turn power ON
again.
■ AM/FM narrow mode
FM narrow mode is only available for the Europe and Italy ver-
sions. AM mode (receive only) is only available for the U.S.A.
and S. America versions. Typically, AM mode is used for the
air band (118–135.995 MHz).
When pushing [PTT], a beep tone sounds indicating the
mode is AM mode. The transceiver cannot transmit in AM
mode.
q Select the mode/channel you wish to set the mode to, such
as VFO mode or memory/call channel.
w Push the desired band’s [
(MAIN)EDIT] for 2 sec. to enter the
edit screen.
•Push [CHG/L] if [(MAIN)EDIT] is not displayed.
e Push [MODE] to set the mode to FM wide/FM narrow or
AM/FM wide.
r If you want to set other channels, rotate the right-hand tun-
ing dial. Repeat e to select the desired frequency.
t Push [ï] to exit the edit screen.
The Europe and Italy versions of the IC-2800H comply with
European regulations regarding narrow FM bandwidth op-
eration on amateur transceivers. Wide and narrow FM op-
eration differ in specifications.
■ Fuse replacement
If the fuse blows or the transceiver stops functioning, find the
source of the problem if possible, and replace the damaged
fuse with a new, rated one (FGB 20 A) as shown below.
20 A