Icom IC-7610

8
SET MODE
8-4
Function (Continued)
MENU
» SET > Function
[SPEECH/LOCK] Switch (Default: SPEECH/LOCK)
Selects
SPEECH
action.
Lock Function (Default: MAIN DIAL)
This function electronically locks
MAIN DIAL
or the
panel display* to prevent accidental changes.
* Keys and dials are also locked except for
AF RF/SQL
, ,
KEY
SPEED
PITCH
,
POWER
,
and
SPEECH
.
Memo Pad Quantity (Default: 5)
Sets the number of memo pad channels.
MAIN DIAL Auto TS (Default: High)
Sets the Auto Tuning Step function for
MAIN DIAL
.
When rapidly rotating
MAIN DIAL
, the tuning step
automatically changes according to the rotation speed.
MAIN/SUB DIAL Select (USB DIAL–SUB Only)
(Default: MAIN/SUB)
Selects whether
MAIN DIAL
changes only the Main
band frequency, or changes both the Main and Sub
band frequencies, depending on which band is
selected.
L This is convenient when using the optional RC-28 remote
encoder to change the Sub band frequency.
MAIN/SUB Tracking [MAIN/SUB] Switch
(Default: OFF)
Assigns the Main and Sub band tracking function to
the
MAIN/SUB
key.
MIC Up/Down Speed (Default: Fast)
Sets the response speed of [∫]/[√] on the supplied
microphone when holding them down.
Quick RIT/∂TX Clear (Default: OFF)
Selects the operation of
CLEAR
for the RIT and ∂TX
functions.
[NOTCH] Switch (SSB) (Default: Auto/Manual)
[NOTCH] Switch (AM) (Default: Auto/Manual)
Selects the notch function used in the SSB or AM
mode.
FILTER Screen MAIN/SUB Select
(Default: Auto (by FILTER, PBT Operation)
Selects whether or not to automatically switch the IF
lter or Twin PBT settings when Main and Sub bands
are switched between each other, while displaying the
FILTER screen.
SSB/CW Synchronous Tuning (Default: OFF)
Turns the Displayed Frequency Shift function ON or
OFF.
This function automatically shifts the frequency to
match the CW pitch when the operating mode is
toggled between SSB and CW.
CW Normal Side (Default: LSB)
Selects the carrier point in the CW normal mode.
Screen Keyboard Type (Default: Full Keyboard)
Sets the keyboard entry type to Ten-Key or Full
Keyboard.
Screen Full Keyboard Layout (Default: English)
Select the on-screen keyboard layout between
English, German and French.
Screen Capture [POWER] Switch (Default: OFF)
Assigns the Screen Capture function to
POWER
.
Screen Capture Keyboard [Print Screen]
(Default: OFF)
Assigns the Screen Capture function to the [Print
Screen] key on the USB keyboard.
Screen Capture Storage Media (Default: SD Card)
Selects the SD card or USB ash drive to save screen
capture data.
Screen Capture File Type (Default: PNG)
Selects the le format for the Screen Capture function.
Calibration Marker (Default: OFF)
Turns the reference frequency calibration marker ON
or OFF.
REF Adjust
Adjusts the internal reference frequency.
NOTE: The default setting of “REF Adjust” may differ
slightly, depending on the transceiver’s version.