EasyManuals Logo

Icom IC-80AD User Manual

Icom IC-80AD
188 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #4 background imageLoading...
Page #4 background image
iii
FCC INFORMATION
• FOR CLASS B UNINTENTIONAL RADIATORS:
This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to part 15 of the
FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential instal-
lation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance
with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that inter-
ference will not occur in a particular installation. If this equip-
ment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment
off and on, the user is encouraged to try to correct the inter-
ference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
Increase the separation between the equipment and re
-
ceiver.
Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician
for help.
For U.S.A. only
CAUTION: Changes or modifications to this device, not
expressly approved by Icom Inc., could void your authority to
operate this device under FCC regulations.
PRECAUTIONS
KEEP away from heavy rain, and never immerse the
IC-80AD in the water. The transceiver meets IPX4* require-
ments for splash resistance. However, once the transceiver
has been dropped, splash resistance cannot be guaranteed
because of possible damage to the transceiver’s case or wa-
terproof seal.
* Only when the supplied battery pack (or optional battery
case), antenna and jack cover are attached.
NEVER operate or touch the transceiver with wet hands.
This may result in an electric shock or may damage the trans-
ceiver.
Even when the transceiver power is OFF, a slight current still
flows in the circuits. Remove the battery pack or batteries
from the transceiver when not using it for a long time. Other-
wise, the installed battery pack or batteries will become ex-
hausted, and will need to be recharged or replaced.
Important notes when using GPS receiver
Please do not use the HM-189GPS close to the transceiver’s
antenna. The transmit signal may cause GPS receiver mal-
function.

Table of Contents

Other manuals for Icom IC-80AD

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Icom IC-80AD and is the answer not in the manual?

Icom IC-80AD Specifications

General IconGeneral
BrandIcom
ModelIC-80AD
CategoryTransceiver
LanguageEnglish

Related product manuals