Icom IC-91AD - Page 41

35
7
DV MODE OPERATION (Optional UT-121 is required for IC-91A)
7
y Push [6/M.N](
≈≈
) to select 2nd digit, then rotate [DIAL]
†
to
select the desired character or code.
• Push [6/M.N](
≈≈
) to move the cursor right; push [4/DUP](
ΩΩ
) to
move the cursor left.
• 2nd digit blinks (1st digit stops blinking).
u Repeat the steps t and y to enter your own call sign.
• Up to a 8-digit of call sign can be set.
• If un-necessary character is entered, push [6/M.N](
≈≈
) or
[4/DUP](
ΩΩ
) to select the character, then push [1/SCOPE](CLR)
to erase the selected character, or push and hold
[1/SCOPE](CLR) for 1 sec. to erase following all characters from
the cursor.
• When programming a note (Up to a 4-digit for operating radio
type or area, etc.), go to step !0.
i Push [6/M.N](
≈≈
) several times to set the cursor beside “/”
indication.
o Repeat steps t to y to program the desired 4-character
note.
!0 Push [5/SKIP](ï) to store the programmed call sign with
note and returns to MY CALL SIGN screen.
!1 Push [MENU/LOCK] to return to frequency indication.
M01M01
MYCALL MYCALL
/IC91 /IC91
:SET
:BACK
:SEL
:EDIT
CLR:CLR
MY CALL SIGN
r
M01M01
M†
/
MY CALL SIGN
r
:SET:SET
:SEL:SEL
:CUR:CUR
CLR:CLRCLR:CLR
A/a:CHARA/a:CHAR
AB
1
2
3
4
5
6
8
9
10
11
12
13
14
15
16
17
18
19
†
[DIAL] ↔ [2/SCAN](
∫∫
)/[8/TS](
√√
) [5/SKIP](ï) ↔ [6/M.N](
≈≈
)