Icom IC-91AD - Page 43

37
7
DV MODE OPERATION (Optional UT-121 is required for IC-91A)
7
NOTE: During the call sign programming mode (r to u),
push [0/CQ] to set “CQCQCQ,” and push [0/CQ] again to
return to the previously stored call sign.
✔ For your information
The IC-91A/91AD has call sign edit record function.
This function selects and store into a blank call sign memory
channel automatically when editing a call sign that stored in a
call sign memory, regular memory or call channel with the de-
fault setting. (“FULL” is displayed when all call sign memory is
programmed.)
The edited call sign can be over-written when the setting of
the EDIT RECORD is set to OFF or SELECT.
(p. 95)
However, the programmed call sign in regular memory and
call channel must be over-write the regular memory and call
channel themselves. (Temporarily operation is possible.)
†
[DIAL] ↔ [2/SCAN](
∫∫
)/[8/TS](
√√
) [5/SKIP](ï) ↔ [6/M.N](
≈≈
)
1
2
3
4
5
6
8
9
10
11
12
13
14
15
16
17
18
19