Icom IC-91AD - Page 65

59
7
DV MODE OPERATION (Optional UT-121 is required for IC-91A)
7
DD
GPS message programming
qEnter “GPS” in message/position set mode.
• GPS MESSAGE screen is displayed.
wPush [6/M.N](
≈≈
) to select the message edit condition.
• The 1st digit of the message blinks.
eRotate [DIAL]
†
to select the desired character or symbol.
• Push [3/LOW](A/a) to change the character group from “AB” (al-
phabetical characters; capital letters), “ab” (alphabetical charac-
ters; small letters), “12” (numbers) and “ !”” (symbols) in
sequence.
rPush [6/M.N](
≈≈
) to select 2nd digit, then rotate [DIAL]
†
to
select the desired character or code.
• Push [6/M.N](
≈≈
) to move the cursor right; push [4/DUP](
ΩΩ
) to
move the cursor left.
• 2nd digit blinks (1st digit stops blinking).
tRepeat the steps r and t to enter the desired message.
• Up to 20-character message can be set.
yPush [5/SKIP](ï) to store the message.
uPush [MENU/LOCK] to return to frequency indication.
DATA:DATA: AB
Hellow!Hellow!
†
:SET:SET
:SEL:SEL
:CUR:CUR
CLR:CLRCLR:CLR
GPS MESSAGEGPS MESSAGE
A/a:CHARA/a:CHAR
r
DATA:DATA: ABAB
†
:SET:SET
:SEL:SEL
:CUR:CUR
CLR:CLRCLR:CLR
GPS MESSAGEGPS MESSAGE
A/a:CHARA/a:CHAR
r
MENU screen ➪ MESSAGE/POSITION ➪ GPS
(Push [MENU/LOCK]) (Rotate [DIAL]
†
, then push [5/SKIP](ï)
†
.)
†
[DIAL] ↔ [2/SCAN](
∫∫
)/[8/TS](
√√
) [5/SKIP](ï) ↔ [6/M.N](
≈≈
)
1
2
3
4
5
6
8
9
10
11
12
13
14
15
16
17
18
19