84
10 PRIORITY WATCH
DD
VFO scan watch
qSet the watching channel(s).
For memory channel watch:
Select the desired memory channel.
For call channel watch:
Select the desired call channel.
For memory scan watch:
Select memory mode, or the desired bank group; then,
push and hold [2/SCAN] for 1 sec. to start memory/bank
scan.
While scanning memory/bank channels:
Starts memory/bank scan first. Memory/bank scan can-
not be started after VFO scan is started.
wEnter “PRIO WATCH” in scan set mode. (p. 00)
e Rotate [DIAL]
†
to select “ON.”
• Select “BELL” if the priority beep function is necessary.
r Push [VFO/MHz] to exit scan set mode and start the
watch.
•“PRIO” indicator appears.
tPush and hold [2/SCAN] for 1 sec. to enter scan type se-
lection condition.
yRotate [DIAL] to select the desired scan type from “ALL,”
“BAND” and “PROG-xx
(xx= 0–24),” “DUP.”
uRelease [2/SCAN] to start the VFO scan watch.
• The transceiver checks the memory/bank channel(s) or call
channel every 5 sec.
• The watch resumes according to the selected scan resume con-
dition. (p. 00)
i Push [VFO/MHz] to cancel the watch.
¥ During priority watch
Searches VFO frequencies
for 5 sec.
Pauses on a memory or
call channel when a sig-
nal is received.
¥ During priority watch with priority beep
Emits beep and blinks S indicator when a signal is re-
ceived on a memory or call channel.
PRIOPRIOFMFM
A
145 000
µ
000000
PRIOPRIOFMFM
A
888800
P SKIPSKIP
PRIOPRIOFMFM
A
145 000
µ
000000
PRIOPRIOFMFM
A
888800
P SKIPSKIP
To Next Page
Loading...
Need help?
General
