8
4
MEMORY PROGRAMMING
D Setting lockout channels
In order to speed up the scan periods, you can set memory
channels you don’t wish to be scanned as lockout channels.
q Push [V/M] to select the Memory mode, if necessary.
•“
X
”appears.
w Rotate [DIAL] to select a memory channel to set as a lock-
out channel.
e Hold down [SCAN] for 5 sec-
onds to toggle the lockout
setting ON or OFF.
•“LOCK OUT” appears when
the channel is set as a lockout
channel.
The transceiver has 99 memory channels for storage of of-
ten-used frequencies.
q Push [V/M] to select the VFO
mode, if necessary.
w Rotate [DIAL] to select the
desired frequency.
•Push[TS](DIAL)oneormore
times to use the dial select
function, if desired.
e Hold down [MW](V/M) for 5
seconds to enter memory
programming mode.
•“X ” and memory channel
number appear.
r Rotate [DIAL] to select the
desired memory channel
number.
t Hold down [MW](V/M) for 1
second to program the infor-
mation into the channel and
return to VFO mode.
•Toclearthememoryinforma-
tion,holddown[SQL]for1sec-
ond.
*NOTE: The VFO/memory switch [V/M] and the memory
write switch [MW] functions may not be available, de-
pending on version.
Memory channel 8 is set
as a lockout channel.
■ Programming a memory channel
To Next Page
Loading...
Need help?
General
