Icom IC-M412 - DSC OPERATION - POSITION REQUEST; Transmitting a Position Request Call

28
6
DSC OPERATION
New2001
n Transmitting DSC calls (Continued)
D Transmitting a Position Request call
Transmit a Position Request call when you want to know a
specified ship’s current position, etc.
q Push [MENU] to enter the DSC menu.
w Push [Y] or [Z] to select “POS REQUEST,” then push
[ENT].
Scrolls
e Push [Y] or [Z] to select a desired pre-programmed Indi-
vidual address or “MANUAL INPUT,” then push [ENT].
 •TheIDcodefortheindividualcanbesetinadvance.(p.14)
 •When“MANUALINPUT”isselected,setthe9-digitMMSIID
code for the individual you wish to call with [Y] or [Z]. (See
About Manual Inputting on page 22.)
Scrolls
r After step e, Channel 70 is automatically selected and
“READY” appears in the channel comment display.
Push
The last digit
*This illustration describes with “MANUAL INPUT”
selection in step e.
t Push [ENT] to transmit the Position Request call.
 •IfChannel70isbusy,thetransceiverstandsbyuntilthechannel
becomes clear.
Tr ansmitting
y After the Position Request call has been transmitted, re-
turn to normal operation (before entering the DSC menu).
Scrolls