Icom IC-M424 - Deleting Individual;Group ID

13
4
BASIC OPERATION
Call channel programming ■
You can program the Call channel with your most often-used
channel in each channel group for quick recall.
Select the desired channel group (INT, USA or CAN) to be q
programmed. (p. 10)
Hold down [16/C] for 1 second to select the Call channel of w
the selected channel group.
 •“CALL”andtheCallchannelnumberappear.
Hold down [16/C] again for 3 seconds (until a long beep e
changes to 2 short beeps) to enter the Call channel pro-
gramming mode.
Rotate Dial or push [ r ∫](CH)/[√](CH) to select a channel.
Push [ENT] to program the displayed channel as the Call t
channel.
 •Push[CLEAR]tocancel.
Channel name programming ■
Each channel can be assigned a unique alphanumeric ID of
up to 10 characters.
Capital letters, 0 to 9, some symbols (! " # $ % & ' ( ) * + , – .
/[\]^_:;<=>?)andaspacecanbeinput.
Push [ q ∫](CH) or [√](CH) to select a channel.
 •First,cancel theDualwatch,Tri-watchor Scanfunction,if acti-
vated.
Push [NAME] to open the channel name programming w
screen.
 •Ablackboxisdisplayedontherstcharacter.
Enter the desired channel name in the following manner: e
 •SelectadesiredcharacterusingDial,or[∫]/[√]/[Ω]/[≈].
 •Push[ENT]tosetit.
 •Tomovethecursor,selecteitherarrow,“←” or “→,” then push
[ENT].
 •Select“SPACE,”thenpush[ENT]toinputaspace.
 •Select“DELETE,”thenpush[ENT]todeleteacharacter.
 •Push[CLEAR]tocancelandreturntothepreviousscreen.