Icom IC-M424 - 8 OTHER FUNCTIONS; Intercom operation

63
7
DSC OPERATION
Receiving a Test Acknowledgement Call D
When a Test Acknowledgement Call is received:
The alarm sounds for 2 minutes. ➥
“RCVD TEST ACK” pops up. The LCD backlight blinks for ➥
2 minutes.
Push [ALARM OFF] to stop the alarm and the blinking q
backlight.
 •If[ALARMOFF]isnotpushedwithin2minutes,thenextscreen
may appear, depending on the received Category.
Push a softkey to select your desired action. w
[EXIT]
➥ Push to return to the normal operating mode.
  •ThetransceiverexitstheDSCmode.
  •“ ” continues to blink and the Call is stored in the Received
Call Log.
Received Call log ■
The transceiver automatically stores up to 50 distress mes-
sages and 50 other messages, and they can be used as a
supplement to your logbook.
•Whileinthenormaloperatingmode,“ ” blinks in the upper right
corner of the LCD when there is an unread DSC message.
Distress message D
Push [LOG] to enter “RCVD CALL LOG” in the DSC CALLS q
menu, or you can enter it through the Menu screen.
MENU ➪ DSC Calls ➪ Received Call Log
(Push [MENU]) (Rotate Dial, then push [ENT].)
Push [ w Y] or [Z] to select “Distress,” then push [ENT].
 •TheDistressmessagesarestoredin“Distress.”
 •“ ” appears when there are unread DSC messages.
 •“ ” appears when there are no unread DSC messages.
 •NoiconappearswhentherearenoDSCmessages.