Icom IC-M424 - D Programming Group ID

21
7
DSC OPERATION
Programming Group ID D
Enter “GROUP ID” in the DSC SETTINGS menu. q
Push [ADD]. w
 •The“GROUPID”programscreenisdisplayed.
Enter a desired group ID in the following way: e
 •SelectadesirednumberusingDial,or[Y]/[Z]/[Ω]/[≈].
 •Push[ENT]orDialtosetit.
 •Tomovethecursor,selecteitherarrow,“←” or “→,” then push
[ENT] or Dial.
The first digit is fixed as ‘0’ for a Group ID.
The first two digits are ‘0’ for any Coast station ID.
Repeat step r e to input the specific 9 digits group code.
After entering the 9 digit code, push [ENT] or Dial to set it. t
 •TheGroupIDnameprogrammingscreenisdisplayed.
Enter a desired 10 digit ID name in the following way: y
 •SelectadesiredcharacterusingDial,or[Y]/[Z]/[Ω]/[≈].
 •Push[ENT]orDialtosetit.
 •Tomovethecursor,selecteitherarrow,“←” or “→,” then push
[ENT] or Dial.
 •Push[123],[!$?]or[ABC]toselectacharactergroup.
After entering the ID name, select “FINISH” using Dial, or u
[Y]/[Z]/[Ω]/[≈], then push [ENT] or Dial to program it.
 •The“GROUPID”listscreenisdisplayed.
Push [MENU] to exit the MENU screen. i
MENU ➪ DSC Settings ➪  Group ID 
(Push [MENU]) (Rotate Dial, then push [ENT].)