Icom IC-M510E

68
1
7
4
10
15
18
2
8
13
5
11
16
3
9
14
6
12
17

9
Selecting in the AIS list:
1. Open the list screen.
Target/Danger/Friend list
2. 
3. Push
NAV
.
• “Start navigation. Are you sure?” is displayed.
4. Push
OK
to start navigation.
• The plotter screen is displayed, and the transceiver starts to navigate.
•
is displayed on the plotter screen.
TIP: 
1. Repeat steps 1 and 2.
2. Push
Details

• The “Details” screen is displayed.
3. Repeat steps 3 and 4.
D Resetting navigation
The transceiver resets the start position, and restarts
navigation from your current position.
L The function works only when the transceiver is receiving
valid GPS signals.
L The function cannot work while in the MOB mode, or when
the transceiver does not navigate.
1. Open the “Reset Navigation” screen.
[MENU] > Navigation > Reset Navigation
• “Reset navigation. Are you sure?” is displayed.
2. Push
OK
.
• The transceiver resets the start position, and restarts
navigation from your current position.
D Stopping navigation
1. Push
Stop NAV
to stop navigation.
• “Stop navigation. Are you sure?” is displayed.
2. Push
OK
.
• The transceiver stops to navigate, and then returns to
the previous screen.