Icom IC-R6 User Manual

50
9
SET MODE
New2001
9
D Auto power OFF (AP OFF)
The receiver can be set to automatically turn OFF, and
sound a beep, after a specified period when no key opera-
tions are performed.
OFF (default), times of 30, 60, 90, 120 minutes and BUSY
can be specified. The (repetitive) period is retained even
when the receiver is turned OFF, even by the auto power
OFF function. To cancel the function, select “OFF”.
When “BUSY” is selected, the receiver will automatically turn
OFF when no key operations are performed and no signal is
received for 3 minutes.
D Scan pause timer (PAUSE)
Selects the scan pause time. When receiving signals, the
scan pauses according to the scan pause time.
(default: 10SEC)
• 2–20SEC : The scan pauses for 2–20 seconds on a
received signal, and is selected in 2 seconds
steps.
• HOLD : The scan pauses on a received signal until it
disappears. Rotate [DIAL] to resume manually.
D Scan resume timer (RESUME)
Selects the scan resume time. The scan resumes after the
specified period after the received signal disappears.
(default: 2SEC)
• 0SEC : The scan resumes immediately after the
received signal disappears.
• 1–5SEC : The scan pauses 1–5 seconds after the
received signal disappears.
• HOLD : The scan pauses on the received frequency,
even if the signal disappears. Rotate [DIAL]
to manually resume the scan.
The scan resume timer must be set shorter than the scan
pause timer, otherwise this timer will not be activated.
D Scan stop beep (STOP B)
Turns the scan stop beep function ON or OFF (default).
When the function is activated (“ON” is selected), a long
beep will sound each time a signal is received during a scan.

Icom IC-R6 Specifications

General

Product color	Black
Channels quantity	1550 channels
Supported radio bands	AM, FM
Battery type	AA
Number of batteries supported	2
Impedance	16 Ω
Frequency range	0.1 - 1309.995 MHz
Product type	Portable CB radio
Housing material	-

Weight and Dimensions

Depth	29.8 mm
Width	58 mm
Height	86 mm
Weight	200 g