Icom IC-R6 - Page 67

54
New2001
9
SET MODE
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
• Changing a program scan link
q Push [MODE] to enter the program scan link setting.
w Rotate [DIAL] to select the program scan link number
that you want to change.
e Push [MODE], then rotate [DIAL] to select the option,
“ADD” or “CLEAR.”
r Rotate [DIAL] to select the desired program scan.
• When “ADD” is selected in step e, only non-linked pro-
gram scans are displayed. When “CLEAR” is selected in
step e, only linked program scans are displayed.
t Push [MODE] to set the program scan link setting.
y Repeat steps r and t to add or clear the program scan
to or from the link, or push [TS] twice to exit the program
scan link setting.
• Changing a program scan link name
q Push [MODE] to enter the program scan link setting.
w Rotate [DIAL] to select the program scan link number
that you want to change.
e Push [MODE], then rotate [DIAL] to select “NAME.”
r Push [MODE] to enter the name programming.
t While holding down [FUNC], rotate [DIAL] to select the
desired character, number, symbol or space.
• Rotate [DIAL] right or left to move the cursor right or
left, respectively.
y When you are finished entering a name, push [MODE] to
save the name and then exit the name programming.
u Push [TS] twice to exit the program scan link setting.
i Push [TS] to exit the Set mode.