3
FREQUENCY AND CHANNEL SETTING
14
[EXAMPLE]: Setting the frequency to 145.360 MHz.
■ Frequency or channel selection via the keypad
D
Frequency
q Assign the main band to the desired display with [MAIN].
w Select VFO mode with [VFO].
e Push 6 digit keys to input a frequency.
•Push [•] to input the frequency starting from the 100 kHz digit.
•When a digit is mistakenly input, push [(VFO)CLR] and input from
the beginning.
•“0,” “2,” “5” and “7” are acceptable for the 1 kHz digits (depending
on the 10 kHz digit).
•Any frequency in the receive frequency range can be selected,
regardless of the operating band.
D Memory channels
q Assign the main band to the desired display with [MAIN].
w Select memory mode with [MR].
e Push 2 digit keys to select the desired memory channel.
•The first ten memory channels (00–09) are preceded by a “0.”
•To select scan edge channels, 1A to 5B, use [•(M)(DTMF•M)] for
“A” and [#(T SCAN)] for “B.”
•Only programmed memory channels can be selected.
[EXAMPLE]: Selecting memory channel 43 (when channel 43 is already programmed).
To Next Page
Loading...
Need help?
General
