MEMORY/CALL PROGRAMMING
6
22
■ General
The transceiver has 100 memory channels (plus 5 pairs of
scan edge channels) and 1 call channel on each band for
storage of often-used frequencies.
Avionics band frequencies are stored in the VHF memory
channels (U.S.A. and Asia versions only).
D Memory/call channel contents
The following information can be programmed into memory/
call channels:
•Operating frequency
•8-digit memory name*
1
•Duplex direction (DUP or –DUP) with an offset frequency
(pgs. 19, 20)
•Subaudible tone encoder or tone squelch ON/OFF (pgs. 19,
32)
•Subaudible tone and tone squelch frequencies (pgs. 20, 32)
•Skip information*
2
(p. 30)
*
1
Except for call channels.
*
2
Except for the scan edge memory channels.
■
Programming during selection
q Assign the main band to the desired display with [MAIN].
w Select VFO mode with [VFO].
e Set the desired frequency:
➥ Set the frequency using the keypad or [DIAL].
➥Set other data (e.g. offset frequency, duplex direction,
subaudible tone frequency, etc.), if required.
r Push [S.MW] momentarily to indicate memory channels.
•Do not hold [S.MW] for more than 0.5 sec., otherwise the mem-
ory channel will overwrite the displayed number.
t Rotate [DIAL] to select the desired channel.
•Call channel (CAL) and scan edge channels (1A–5B), as well as
regular memory channels, can be programmed in this way.
y Push [(S.MW)MW] for 2 sec. to program.
To Next Page
Loading...
