EasyManuals Logo

Icom IC-W32A User Manual

Icom IC-W32A
49 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #43 background imageLoading...
Page #43 background image
TROUBLESHOOTING
11
39
If your transceiver seems to be malfunctioning, please check
the following points before sending it to a service center.
PROBLEM POSSIBLE CAUSE SOLUTION REF.
No power comes on. The battery is exhausted.
(A slight current ows in the circuits even when
the power is OFF).
Poor plug connection to the external DC power
cable.
Charge the battery pack or place new dry cell
batteries in the battery case.
(Remove the battery pack if you will not be using
the transceiver for a long time.)
Check the connector or remove and replace the
cable.
pgs.
9, 10
No sound comes from
the speaker.
Squelch level is too deep. (e.g. SQ8)
Volume level is too low.
Set squelch to automatic (AT).
Set the desired bands [VOL] to a suitable level.
p. 17
p. 17
Transmitting is
impossible.
The battery is exhausted.
Avionics band frequency (U.S.A./Asia only) or
weather channel (U.S.A. only) is selected.
Charge the battery pack or place new dry cell
batteries in the battery case.
Set an amateur frequency.
pgs.
9, 10
p. 13
Frequency cannot be set. Memory mode or call channel is selected.
Weather channel (U.S.A. only) is selected.
Lock function is activated.
Push [VFO] to select VFO mode.
Push [BAND] to select an amateur band or
avionics band.
Push [
(CALL)
LOCK] for 2 sec. to cancel the
function.
p. 12
p. 13
p. 15
Scan does not start. The squelch is open.
Call or weather channel (U.S.A. only) is
selected.
Set squelch to automatic (AT) or the squelch
closed point (SQ1 or more).
Push [BAND] to select an amateur band, memory
channel or avionics band.
p. 17
p. 13
No contact possible with
another station.
The transceiver is set to semi-duplex.
The output power is set to low.
Set to simplex.
Push [H/L] to select high power.
p. 19
p. 17

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Icom IC-W32A and is the answer not in the manual?

Icom IC-W32A Specifications

General IconGeneral
BrandIcom
ModelIC-W32A
CategoryTransceiver
LanguageEnglish

Related product manuals