Icom MR-1220 Series - Page 51

46
INSTALLATION AND CONNECTIONS
9
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
Installing the display unit
D Wall mounting
The display unit can be mounted to a at surface, such as an instrument panel, using the M6 mounting bolts.
1. Remove the 4 screw hole seals from the 4 corners
of the display unit.
BE CAREFUL! NEVER use your nger nail to
remove the seal. Otherwise, you may injure your
nail.
2. Using the supplied display unit template, carefully
cut a hole in the instrument panel, or wherever
you want to mount the display unit.
3. Drill 4 holes for the mounting screw.
4. Firmly slide the display unit through the hole.
Flat washer
Spring washer
M6 mounting bolt
Screw hole seal
14.5 mm (9/16 inch)
Instrument panel
M6 mounting
bolt
Spring washer
Flat washer
5. Fix the four corners of the display unit with the flat
washers, spring washers, and M6 mounting bolts.
L The screw hole depth on the display unit is 14.5 mm
(9/16 in). Select the mounting bolts of the length that
ts the thickness of the instrument panel.
MR-1220
301 (11.9)
119.2 (4.7)
30 (1.2)
74 (2.9)
294 (11.6)
323.5 (12.7)
147 (5.8)147 (5.8)
Unit: mm (inch)