Icom MR-1220 Series - Page 63

58
MAINTENANCE
10
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
Settings for a maintenance
D Resetting to the defaults
When you recongure your settings, you can reset the
radar settings to the factory defaults.
There are 2 types of resetting. Select an appropriate
way, according to your situation.
• Settings Reset Resets settings other than in the
Initial menu.
• Factory Reset Resets all the settings to the factory
defaults.
NOTE: You can reset the settings only in the
Standby mode.
1. Confirm the radar is in the Standby mode, if
necessary, push [TX (SAVE)]/[
] to enter
the Standby mode.
2. Select “Settings Reset” or “Factory Reset” in the
Initial menu.
[MENU]/[
] > Initial > Settings Reset
[MENU]/[
] > Initial > Factory Reset
3. Push [ENTER]/[
].
• <OK> and <Cancel> are displayed.
4. Push [◄] to select <OK>, and then push [ENTER]/
[ ] to reset the settings.
• After Factory Reset has been done, the radar
automatically restarts and the Initial screen as shown
below is displayed.
Select a language, and then push [ENTER]/
[
] to boot up the radar.
L The selectable language differs, depending on the
display unit version.