IDEATEC S.A. - Z.I. de Noville-les-Bois - rue Léopold Génicot 19A - 5380 Fernelmont, Belgium - Tel: +32(0)81 42 00 10 - Fax: +32(0)81 57 91 70 - E-mail: info@ideatec.be
User Guide POLARIS V1.0 - Console V1.16 - Module V2.16
Page 19
5.
5mm
MAX
Fig.1
Fig.2
ÜChoose the best place to install the console in the vehicle.
Ü Locate and note the 2 fixation holes on the back side of the console (Fig.1).
Ü Place the console perfectly.
Ü Block the 2 head screws provided.
ÜATTENTION: The force applied to tighten the screw depends on wall type. It must never be too high. The
manufacturer will not provide repairs under warranty if the back side of the console is broken due to exceeded
tightening force.
5.2 FSP-4K, FSP-6K & FSP-9K Housing
Ü Fix the console only with the screws provided.
ÜATTENTION: The force applied to tighten the screw depends on wall type. It must never be too high. The
manufacturer will not provide repairs under warranty if the top side of the console is broken due to exceeded
tightening force.
Use screws, nuts, and washers provided by the manufacturer.
Using other, longer screws in the back of the console may seriously damage its internal parts. The
screws can never enter more than 5mm inside the box to avoid any damage.
The manufacturer cannot assure any warranty or accept liability if other fixing elements or screw,
nuts, and washers are used to install the console.
Elements installation
5.3 Touchscreen Console & FSP Panel Mouting
The safety of future users of this product depends on your installation. Therefore, it is critical that
you read, understand, and follow all instructions contained in this installation guide.
Use a flat surface to mount the console.
To Next Page
Loading...