IDEATEC S.A. - Z.I. de Noville-les-Bois - rue Léopold Génicot 19A - 5380 Fernelmont, Belgium - Tel: +32(0)81 42 00 10 - Fax: +32(0)81 57 91 70 - E-mail: info@ideatec.be
User Guide POLARIS V1.0 - Console V1.16 - Module V2.16
1.
Page 2
Safety and precautions
The safety of future users of this product depends on your installation. Therefore, it is critical that you read,
understand, and follow all instructions contained in this installation guide.
Some instructions and precautions that must be applied are listed below (see page 3 too) :
I To install this equipment correctly, it is essential to have the understanding and the technical skills for the installation
of automobile electronics.
I Place this installation guide in a safe place and refer to it when necessary and for each installation. This manual
must be delivered to the end user.
I Before wiring, disconnect the cable from the negative battery terminal. Failure to do so may result in electric shock
or injury due to electrical shorts. Connect again the cable on the negative battery terminal once the installation is
completely finished.
I Use only in cars with a +12 or +24 volt negative ground (Check with your car manufacturer if you are not sure).
Failure to do so may result in fire, etc.
I The IDEATEC system must be powered by a DC voltage between + 10V and +30V. Use of AC voltage or DC
voltage greater than + 30V can result in property damage, fire hazard, serious injury or fatal injury to yourself and /
or others.
I Never install any devices or accessories inside the airbag deployment area. Such installation might reduce the
effectiveness of the airbag or prevent it from being deployed. It can also potentially damage or dislodge the device,
causing serious or fatal injuries.
I Installation of the equipment must comply with local and national electrical codes.
I It is imperative to dimension correctly all wires installed and connected to the positive battery terminal (see the chart
on page 3) and protected by a proper fuse placed as close as possible to the battery.
I To ensure a correct operation of the device installed, it is necessary to make a perfect connection to the negative
terminal. The negative output of the device must be connected to the negative terminal of the battery as directly as
possible. The same applies to any elements controlled by the installed device.
I Do not allow cables to become entangled in surrounding objects. Arrange wiring and cables in compliance with the
manual to prevent obstructions when driving. Cables or wiring that obstruct or hang up on places such as the
steering wheel, shift lever, brake pedals, etc. can be extremely hazardous.
I Position the cables in such a way that they can never be damaged by vehicle vibrations or by impact (metal edge in
direct proximity, mechanical stress on the cable, etc.). Also make sure that all users of the vehicle can never
damage the cables directly or indirectly.
I Make sure that none of the vehicle's original controls are affected by the installed device.
I Do not install the monitor near the passenger seat air bag. If the unit is not installed correctly the air bag may not
function correctly and when triggered the air bag may cause the monitor to spring upwards causing an accident and
injuries.
I If you need to drill a hole in the dashboard, make sure that both sides are completely free to avoid damaging the
vehicle.
I Always install the console or the central unit in a ventilated area, and never close to a heat source. This area must
also be protected against dust and moisture.
I Check that all inductive load connected on the POLARIS output is well equiped by a tranzorb diode or equivalent
which absorbs reverse overvoltages that can be destructive for POLARIS. In case of doubt it is imperative to consult
the technical characteristics of the connected equipment to make sure.
I Failure to follow safety guidelines and instructions may cause material damages, injuries, or death to you and/or to
others.
I If you have problems, do not attempt to repair the unit yourself. Return it to your IDEATEC dealer for servicing.
To Next Page
Loading...