IDEATEC S.A. - Z.I. de Noville-les-Bois - rue Léopold Génicot 19A - 5380 Fernelmont, Belgium - Tel: +32(0)81 42 00 10 - Fax: +32(0)81 57 91 70 - E-mail: info@ideatec.be
User Guide POLARIS V1.0 - Console V1.16 - Module V2.16
Page 57
9.
9.8 MFI Interface Configuration
Please refer to MFI user guide for configuration.
9.7 ADI Interface Configuration
Please refer to ADI user guide for configuration.
9.5 Unitherm-HD Interface Configuration
Please refer to Unitherm-HD user guide for configuration.
9.6 VFI Interface Configuration
Please refer to VFI user guide for configuration.
9.4 OpenLink Module Configuration
Connecting (continued)
As the OpenLink modume takes place of one console, you have to give the right address to the module (address 1, 2
or 3). The default address is the address 1.
The red LED is the power supply monitoring. Do not take care about this LED for configuration.
One of the 3 LED’s shows you the adress of the OpenLink module. The yellow Led on the left side indicates the
address 1, the second one the address 2 and the third yellow LED indicates the address 3. The green LED is not used
in the configuration process.
To go into the configuration mode, the OpenLinl module has to powered up since less than 2 minutes.
Release the plastic cover in front of the push button and make a long press with a pointed tool until the LED’s of the
RJ45 connectors are changing state (see below).
LONG
PRESS
SHORT
PRESS
SHORT
PRESS
SHORT
PRESS
Example : address 1
ADDRESS 1
ADDRESS 2
ADDRESS 3
9.9 EPM-103 Module Configuration
Please refer to EPM-103 user guide for configuration.
To Next Page
Loading...