IDEATEC S.A. - Z.I. de Noville-les-Bois - rue Léopold Génicot 19A - 5380 Fernelmont, Belgium - Tel: +32(0)81 42 00 10 - Fax: +32(0)81 57 91 70 - E-mail: info@ideatec.be
User Guide POLARIS V1.0 - Console V1.16 - Module V2.16
Page 53
FSP-4K FSP-6K FSP-9K
Fig.1
9.
The fixing screws must come again the front face of the FSP console and cannot be tightened as
this may damage the housing. Ideatec S.A. will not provide repairs for damage caused by
excessively high torque.
In order to ensure perfect operation, only screws supplied by the manufacturer are accepted.
Otherwise, unless authorised in writing, the manufacturer will not accept any warranty or liability on
the equipment installed.
9.3.4 FSP housing mouting
FSP consoles can be mounted in optional housing to provide an alternative to wall mounting. The housing for the FSP-
6K and FSP-9K consoles are compatible with multi-directional mounting foot.
Before mouting the FSP console inside the housing, please remove the protective green cover.
Place the FSP console in order to have the RJ45 connectors in front of the holes provided on the back of the housing.
Note that the FSP-6K housing provides only one hole for the RJ45 connector and therefore does not allow to connect
another more FSP console on the same FSP bus.
9.3 FSP Configuration
9.3.3 FSP Protection
FSP consoles are provided with plastic protection to cover the electronic components.
Please fix the plastic cover before connecting the console with bus cable.
Configuration (continued)
To Next Page
Loading...