IDEATEC S.A. - Z.I. de Noville-les-Bois - rue Léopold Génicot 19A - 5380 Fernelmont, Belgium - Tel: +32(0)81 42 00 10 - Fax: +32(0)81 57 91 70 - E-mail: info@ideatec.be
User Guide POLARIS V1.0 - Console V1.16 - Module V2.16
Page 21
1
CM
1 2
2 3 4 5 6 7 8 9 10
3 4 5 6 7 8 9 10
CM
10,0 mm
6.
CHECK THE SCALE (X & Y) AFTER PRINTING
ATTENTION THE DRILLING TEMPLATES WERE CREATED BY THE EDITOR USING A 1:1 SCALE. FOR
THIS REASON, SOME PRINTERS OR PRINTING SOFTWARE MAY CAUSE DISTORTIONS ON
PRINTING. YOU SHOULD VERIFY THE SCALE BEFORE USING THE TEMPLATES BELOW.
6.1 Controlling the Template Scale after Printing
The rulers below allow you to control the scale on the two axes :
Drilling templates
To Next Page
Loading...