IDEATEC S.A. - Z.I. de Noville-les-Bois - rue Léopold Génicot 19A - 5380 Fernelmont, Belgium - Tel: +32(0)81 42 00 10 - Fax: +32(0)81 57 91 70 - E-mail: info@ideatec.be
User Guide POLARIS V1.0 - Console V1.16 - Module V2.16
Page 20
a
5.
ÜTake into account the space around the consoles & modules to be able to
plug and unplug the BUS cable.
5.5 Bus Cable Plugging
Elements installation (continued)
The safety of future users of this product depends on your installation. Therefore, it is critical that
you read, understand, and follow all instructions contained in this installation guide.
ÜChoose a flat surface and use appropriate fixation screws.
ÜAlways install the console or the central unit in a ventilated area, and never close to a heat source.
ÜTake into account the size of the different connectors that will be added to the assembly.
5.4 Installing the POLARIS Central Unit (S, M, L & XL),
OpenLink, Unitherm-HD, VFI, ADI Interfaces & EPM-103
Do not attempt to enlarge
the mounting holes.
iDrilling template on pages 21 to 28
Do not tighten the BUS cable
especially near the connectors, you
can damage the cable or the
connector on the module/console.
Ideatec S.A. cannot accept any
warranty request if the cable is not
installed following the special
recommendations.
To Next Page
Loading...