IDEATEC S.A. - Z.I. de Noville-les-Bois - rue Léopold Génicot 19A - 5380 Fernelmont, Belgium - Tel: +32(0)81 42 00 10 - Fax: +32(0)81 57 91 70 - E-mail: info@ideatec.be
User Guide POLARIS V1.0 - Console V1.16 - Module V2.16
Page 5
Hourmeter
Messages
Stem
Table
3.
To activate several functions at the same time by pressing only one key.
Product description (continued)
Loadshedding configurable for each positive output to save the battery. Configurable with two different
voltage levels.
Hourmeter allows you to measure the use of some equipments.
Thanks to analog input, the main battery of the vehicle can be monitored by POLARIS system. Its
voltage can be compared to the voltage of the auxiliary battery and one of the POLARIS output can be
used to drive a power relay to connect/disconnect the 2 batteries together.
Virtual input is a parameter made by the combination of 2 others parameters. Each input parameter
can be reversed and the 2 parameters can be combined by AND, OR or XOR function. 32 virtual
inputs are available. A virtual input can be a parameter for another virtual input too.
Example : signal activated when +ignition is ON and handbrake is activated or a door is open.
The POLARIS allows you to show messages (status, alarm, etc.) on the screen
As a black box, all parameters changes, chosen during the configuration, are recorded. This change of
status can be read by software SpeedFitter.
Instead of touch screen system for the mass market, the touch screen consoles POLARIS can be
used with gloves to meet the specific requirements of some applications (ambulance, fire department,
etc).
More than 500x pictograms are available to configure the keys of the console.
Create also your own text pictograms with SpeedFitter for the keys of the console.
Canbus interface included inside the POLARIS central unit allows you to read a lot of vehicle status
directly from the CAN network of the vehicle with only 2 wires.
The POLARIS allows you to control a STEM table.
To determine Time ON and Time OFF of the output signal, used for a gun lock for example.
Thanks to the optional Unitherm-HD interface, the POLARIS is also an interface to control
heating/airco systems.
Unitherm-HD is compatible with heating systems like Webasto, Eberspächer, Kalori and usual heater
air exchange / hot water heating systems.
3.1 Main Features (continued)
To Next Page
Loading...